mirror of
git://projects.qi-hardware.com/ben-wpan.git
synced 2024-11-22 22:13:08 +02:00
41 lines
1.3 KiB
Plaintext
41 lines
1.3 KiB
Plaintext
Version 20100903:
|
|
|
|
- changed C7 to 1 nF to debug a signal attenuation problem. Turned out to be
|
|
a bad trace. According to simulations, 22 pF should be more than enough.
|
|
|
|
- added wire connecting uSD-side ground plane to ground plane at outer edge,
|
|
to improve CLK signal return. (Probably unnecessary, too.)
|
|
|
|
- the footprint of the transistor (Q1) is reversed :-( It works after
|
|
converting the chip from SOT to PLCC.
|
|
|
|
- not an erratum, but with experiments showing power-on reset to be
|
|
reliable, we can consider removing the hardware reset circuit. This will
|
|
also simplify the layout.
|
|
|
|
Version 20100908:
|
|
|
|
- SPI activity causes the PLL to unlock. Specifically, toggling nSEL does
|
|
this.
|
|
|
|
- work-around on second 20100908 board: replace the resistive divider with
|
|
a capacitative divider. See sim/cdiv.sch. This is a simple BOM change:
|
|
|
|
C7 -> 0 R
|
|
R3 -> 33 pF
|
|
R4 -> 220 pF
|
|
|
|
Applied work-around also to first 20100908 board after confirming dismal
|
|
performance caused by clock instability.
|
|
|
|
- considering that the clock input has a Vpp of only 400-500 mV, we should
|
|
have a ground plane also under as much of the the clock circuit as
|
|
possible.
|
|
|
|
- via between pins 1 and 32 is too close to the chip for DIY PCBs
|
|
|
|
Version 20100912:
|
|
|
|
- zone fill did not reach upper GND end of antenna. This was not intended,
|
|
but may be harmless or even an improvement.
|