openwrt-xburst/package/broadcom-57xx/src/Makefile

#
# Broadcom BCM57XX Gigabit Ethernet driver make file.
#
#

O_TARGET = bcm57xx.o

EXTRA_CFLAGS += -DDBG=0 -DBCM_PROC_FS=1 -DT3_JUMBO_RCV_RCB_ENTRY_COUNT=256
EXTRA_CFLAGS += -DPCIX_TARGET_WORKAROUND=1 -DINCLUDE_TBI_SUPPORT=1 -DINCLUDE_5701_AX_FIX=1

export-objs :=

obj-y := b57um.o tigon3.o autoneg.o 5701rls.o tcp_seg.o hndgige.o bcmrobo.o
obj-m := $(O_TARGET)

include $(TOPDIR)/Rules.make
(6/6) bcm57xx: package This is the bcm57xx package. I have tested default vlan functions, but I dont have the equipment to test more advanced setups. The default vlan setup seems to be working fine. I also added the activate_gpio parameter which will make the driver activate the switch via gpio before probing for it. I'm not sure which method is best for autoload. For the wrt350n, I need the activate_gpio parameter. But its probably not a good idea to add that to the autoload file. On a system without a bcm57xx switch, isn't it a bad idea to mess with the gpios looking for the switch? Ideally, wouldn't it be best to load the bcm57xx module from broadcom-diag, after it has determined which router its on? I tried using 'request_module' from there, but had no success. For now, I am relying on preinit to load the bcm57xx module with activate_gpio param, after it has failed to load switch_robo and switch_adm. Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11471 3c298f89-4303-0410-b956-a3cf2f4a3e73 2008-06-15 14:11:28 +03:00			`#`
			`# Broadcom BCM57XX Gigabit Ethernet driver make file.`
			`#`
			`#`

			`O_TARGET = bcm57xx.o`

			`EXTRA_CFLAGS += -DDBG=0 -DBCM_PROC_FS=1 -DT3_JUMBO_RCV_RCB_ENTRY_COUNT=256`
			`EXTRA_CFLAGS += -DPCIX_TARGET_WORKAROUND=1 -DINCLUDE_TBI_SUPPORT=1 -DINCLUDE_5701_AX_FIX=1`

			`export-objs :=`

			`obj-y := b57um.o tigon3.o autoneg.o 5701rls.o tcp_seg.o hndgige.o bcmrobo.o`
			`obj-m := $(O_TARGET)`

			`include $(TOPDIR)/Rules.make`