1
0
mirror of git://projects.qi-hardware.com/wernermisc.git synced 2024-12-31 01:11:08 +02:00
wernermisc/labsw/README

37 lines
1.2 KiB
Plaintext
Raw Normal View History

Opto-isolated inputs
--------------------
The C8051F320 needs a current of at least 50 uA to drive an input low.
The current transfer ratio of the opto coupler is 50% or better.
Thus we need an input current of at least 100 uA.
If we allow for a loss of at least 100 mV (yielding a minimum input
voltage of 1.5 V), the protection resistor can be at most 1 kOhm.
If the maximum power dissipation of the protection resistor is
limited to 1 W, we can allow up to 30 mA into 1 kOhm +/- 10%.
The maximum input voltage would thus be 30 V.
Future changes for higher voltages
----------------------------------
The circuit is currently not designed for voltages exceeding about
30 V between any two points !
To allow the use with mains voltages, be it across the relays or be
it as a difference in "ground" potential of separate loops, at least
the following changes will be necessary:
- air gaps must be 2 mm or larger (6 kV)
- conducting elements closer than 2 mm must be isolated if high
voltage may exist between them
In particular, this means:
- the PCB must be coated
- opto couplers may not share the same socket
- the opto coupler headers (inputs and outputs) need wider spacing
- clearances need to be verified