2011-12-16 10:09:43 +02:00
|
|
|
Reengineered M1 case parts
|
|
|
|
|
==========================
|
|
|
|
|
|
|
|
|
|
case.fpd contains an fped-based design of the front and rear panel.
|
|
|
|
|
The geometry is based on
|
|
|
|
|
http://projects.qi-hardware.com/index.php/p/m1/source/tree/master/cad/protocase_v7_laser.dxf
|
|
|
|
|
by Joachim Steiger.
|
|
|
|
|
|
|
|
|
|
This design is fully parametrized and contains the following changes:
|
|
|
|
|
|
|
|
|
|
- the holes for the USB sockets are raised by 1.4 mm, for the M1pre-rc4
|
|
|
|
|
prototype (parameter Iusby):
|
|
|
|
|
http://en.qi-hardware.com/wiki/File:M1pre-rc4-u-A022.JPG
|
|
|
|
|
|
|
|
|
|
- additional hole in the rear panel for a mini-USB cable going to
|
|
|
|
|
the JTAG board (parameters Idbgx and Idbgy, with frame "debug")
|
|
|
|
|
|
|
|
|
|
Known issues:
|
|
|
|
|
|
|
|
|
|
- button holes are a bit too tight
|
|
|
|
|
|
|
|
|
|
- DC connector hole is too tight on all sides
|
2011-12-16 14:37:53 +02:00
|
|
|
|
|
|
|
|
- the IR receiver is blocked
|
