The reset vector is the wrong entry: it starts POST, which re-programs the
board window from a state a payload has already changed. The firmware has a
second entry, 0x3F5788C0, where the boot gate at 0x3F2042D0 branches when it
skips level 1. It begins with DINT, CSR0=STOP on the LANCE, and a board-window
re-program -- exactly what a takeover breaks.
MAME, from the LANCE access log: the payload's last access and the OS's first
are 130 us apart, then pc=3F578940 writes CSR0=0x0004 (STOP) and pc=3FDDCAE0
(the OS driver) re-initialises the chip, after which the OS keeps servicing it.
cmd 6 / vtcmd.py osboot. Unit run pending; the report section is 73.
lance_cmd.c is a payload that drives the LANCE with its own code (no ROM
calls) and answers a command protocol on ethertype 0x88B6, so a unit whose
chip we have taken over can still be inspected:
read (peek), stats, poke, jump, reboot
The reply path was dead for a while and the cause was not the chip: the RX
ring had been grown to 16 entries (0x3020..0x309F) while TXR stayed at
0x3060, so all eight TX descriptors lay inside the RX ring. The chip's RX
write-back set OWN in what we believed were TX descriptors, and every reply
was discarded by transmit_poll() as "owned but not start of packet"
(r 00309A 8000 / w 00309A 0000 in the DMA log). TX ring moved to 0x30C0,
with a compile-time guard so the rings cannot overlap again.
Receive path aligned with the three drivers available locally (4.4BSD
pmax if_le.c, NetBSD am7990.c, Linux 7990.c):
* STP *and* ENP required on one descriptor, else the frame is counted as
chained and dropped rather than parsed from the middle of a buffer;
* the 4-byte FCS the chip writes into the buffer is subtracted, as all
three do (rmd3 - 4);
* re-arm restores RMD2 and clears RMD3, ownership written last;
* TX kick is TDMD|INEA (no reference driver re-writes STRT);
* a TX slot still owned is skipped instead of clobbered.
RX buffers are 1526 B so a full 1514-byte MTU frame fits one descriptor;
1500 B would have chained it.
vtcmd.py drives all of it; bench-sweep.sh sweeps size x rate. Measured on
the real VT1200 (10 Mbit half-duplex hub): 856-858 fps of 1514-byte frames
at 99.9-100% delivery, i.e. wire limited, and 1500 fps of 60-byte frames at
99.8-99.9%. NETWORK_REPORT.md sections 68-72 record the evidence, including
the 64-descriptor build that died with an illegal opcode on the unit and was
reverted.
arti