mirror of
git://projects.qi-hardware.com/ben-blinkenlights.git
synced 2024-11-23 21:23:09 +02:00
Blinkenlights, Demonstrate the use of the uSD slot for DIY hardware
http://projects.qi-hardware.com/index.php/p/ben-blinkenlights/
0c2b98274f
- nanonote.c (nanonote_open): increased register window to include clock and MMC controller registers - nanonote.c (gpio_function): set a pin to function or GPIO - nanonote.c (nanonote_initpgm, nanonote_parseextparams): accept the extended option clk=N where N is the clock frequency in (whole) MHz - nanonote.c (nanonote_enable): if the clock option is set, switch CLK to function and output the specified clock |
||
|---|---|---|
| avrdude | ||
| bbl | ||
| cam | ||
| components | ||
| ext | ||
| nxuart | ||
| ubb | ||
| bbl.brd | ||
| bbl.cmp | ||
| bbl.pro | ||
| bbl.sch | ||
| BOOKSHELF | ||
| Makefile | ||
| README | ||
Ben Blinkenlights ================= This project is a proof of concept implementation of Rikard Lindstrom's idea of using the Ben's 8:10 card slot as a general extension interface also for devices that don't speak MMC or SD/SDIO. The application is a simple LED circuit, as suggested by David Samblas. The 8:10 card slot gives access to six GPIOs, a 3.3 V supply that can be switched on and off by software, and ground. We use a simple form of multiplexing to drive ten LEDs with this interface. Note that one should only light one LED at a time. If multiple LEDs are lit, they will share the current though the common resistor, and will thus be less bright than a single LED.