mirror of
git://projects.qi-hardware.com/ben-blinkenlights.git
synced 2024-11-23 20:33:45 +02:00
Blinkenlights, Demonstrate the use of the uSD slot for DIY hardware
http://projects.qi-hardware.com/index.php/p/ben-blinkenlights/
a3cea3573c
This caused 800x600 images to be cut off, because the line length is not a multiple of 64 bytes. - ubb-vga.c (session): make the allocation a multiple of the DMA transfer size - ubb-vga.c (line): round number of transfers up instead of down - ubb-vga.c (mode_db): line duration of 800x600/54 was a bit to short |
||
|---|---|---|
| avrdude | ||
| bbl | ||
| cam | ||
| components | ||
| ext | ||
| nxuart | ||
| ubb | ||
| ubb-vga | ||
| bbl.brd | ||
| bbl.cmp | ||
| bbl.pro | ||
| bbl.sch | ||
| BOOKSHELF | ||
| Makefile | ||
| README | ||
Ben Blinkenlights ================= This project is a proof of concept implementation of Rikard Lindstrom's idea of using the Ben's 8:10 card slot as a general extension interface also for devices that don't speak MMC or SD/SDIO. The application is a simple LED circuit, as suggested by David Samblas. The 8:10 card slot gives access to six GPIOs, a 3.3 V supply that can be switched on and off by software, and ground. We use a simple form of multiplexing to drive ten LEDs with this interface. Note that one should only light one LED at a time. If multiple LEDs are lit, they will share the current though the common resistor, and will thus be less bright than a single LED.