- cntr/cntr.sch: change input circuit according to ECN0006
- cntr/cntr.sch: make P2_0 yet another version ID input
- cntr/cntr.cmp: surprise, this wasn't checked in either
- cntr/cntr.brd: update for above changes
- cntr/cntr.brd: adjust for resized USB connector
- cntr/cntr.brd: top ground fill was very spotty - removed it
- cntr/cntr.brd: board can now be 100 mil shorter
- cntr/cam/pcb.pl: updated for new board outline
- cntr/cntr.pro, cntr/cntr.brd: reduced PCB edge line width from 15 mil to
5 mil
- cntr/cntr.brd: make edge follow hole for MMCX connector
- cntr/cntr.brd: fill bottom and input area with ground
- cntr/cntr.sch, cntr/cntr.brd (R4): replace 0 Ohm jumper and GND via
P2.1 with vias
- cntr/cntr.pro: added usb_a_plug.lib, mmcx-f-edge.mod, usb_a_plug_smt.mod,
and sot-323.mod
- cntr/cntr.sch, cntr/cntr.brd: reassigned LED and pull GPIO for easier
routing
- cntr/cntr.sch, cntr/cntr.brd: replaced mini-USB receptacle with USB A
plug and removed 0 Ohm resistor previously used for swapping D+/D-
- cntr/cntr.sch, cntr/cntr.brd: changed TVSs on USB from 200 pF 0603 to
100 pF 0402 type
- cntr/cntr.sch, cntr/cntr.brd: replaced basically unterminated 100 mil
header with properly terminated MMCX connector
- cntr/cntr.brd: reduced board width (nominally 15.8 mm) to USB connector
width (16 mm)
- modules/mmcx-f-edge.fpd: swap contacts for compatibility with "BNC"
symbol
- cntr/cntr.sch (VR1, VR2, VR3): reverted change to 0402, because this
would be too difficult to route with current board
- cntr/cntr.sch (VR1, VR2, VR3): change voltage from 5.6 V to 5.5 V,
for compatibility with selected part
- cntr/cntr.brd: updated for value change
quite formidable low-pass filter that almost completely eliminated the
1 MHz signal.
- cntr/cntr.sch, cntr/cntr.brd: changed R1 from 100k to 1k to increase
input bandwidth
