mirror of
git://projects.qi-hardware.com/openwrt-xburst.git
synced 2025-02-02 17:31:05 +02:00
746f915308
Add swconfig support to ramips_esw.c This patch adds swconfig support for ramips_esw: Tested on both D-LINK DIR-300 B1 and Sitecom WL-351 (external rtl8366rb on internal port 5). I've made sure that in the enable_vlan=0 case it behaves like a dumb switch, so external switches should work fine with vlans and verified this on the WL-351. The current state shown by swconfig is always read directly from HW registers, new settings only show after 'swconfig dev rt305x set apply'. Signed-off-by: Tobias Diedrich <ranma+openwrt@tdiedrich.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@33299 3c298f89-4303-0410-b956-a3cf2f4a3e73
This is the buildsystem for the OpenWrt Linux distribution. Please use "make menuconfig" to configure your appreciated configuration for the toolchain and firmware. You need to have installed gcc, binutils, patch, bzip2, flex, make, gettext, pkg-config, unzip, libz-dev and libc headers. Run "./scripts/feeds update" to get the latest package definitions defined in feeds.conf / feeds.conf.default respectively and "./scripts/feeds install" to install symlinks into "package/feeds/*". Use "make menuconfig" to configure your image. Simply running "make" will build your firmware. It will download all sources, build the cross-compile toolchain, the kernel and all choosen applications. You can use "scripts/flashing/flash.sh" for remotely updating your embedded system via tftp. The OpenWrt system is documented in docs/. You will need a LaTeX distribution and the tex4ht package to build the documentation. Type "make -C docs/" to build it. To build your own firmware you need to have access to a Linux, BSD or MacOSX system (case-sensitive filesystem required). Cygwin will not be supported because of the lack of case sensitiveness in the file system. Sunshine! Your OpenWrt Project http://openwrt.org